Your cart is empty.
Your cart is empty.9" Ford 1350 Rearend Pinion Yoke - 5" Long - 28 Spline
Customer
Reviewed in the United States on July 12, 2024
Fits nice and snug on the pinion splines with no slop. Comes with u bolt style straps. Fast shipping!
Mohave green Enterprises Inc.
Reviewed in the United States on September 5, 2021
DO NOT BUY THESE .THE DISTANCE THROUGH THE BORE IS TOO SHORT THE NUT BOTTOMS OUT ON H=THE SPLINES 1/4 INCH BEFORE CONTACTING THE YOKE THE YOKE IS COUNTER BORED TOO MUCH TO USE IT YOU WILL NEED A 1/4 INCH SPACER EITHER AT THE BEARING OR THE NUT SIDE WHICH WILL HAVE TO GO OVER THE SPLINE POORLY BUILT THE OTHER YOKE FROM THIS MANUFACTURER IS THE SAME CHEAP CHINESE CRAP
Paul E.
Reviewed in the United States on January 24, 2021
Everything was as I expected
Theodore Alva
Reviewed in the United States on November 19, 2020
This yoke will work for Ford 9-in style third members OEM and aftermarket. I installed with a Daytona pinion support and work just fine with the standard and or narrow nut. If you plan on installing this on a standard pinion support you will need the spacer approximately a quarter of an inch or .250"
Robert Fajardo
Reviewed in the United States on January 11, 2019
Part was as specified -I would like to add that the fit and finish of the item was great and that this vendor saved me a great deal of effort and expense by having the item available and shipping it expediently
Recommended Products
